Common faults and solutions for the animatronic dinosaur (FAQs)
Some dinosaur theme park users encounter a variety of problems in the process of using large animatronic dinosaur models. How to self-check? Zigong Ocean Art Inc, on this aspect of the experience, the following describes common problems and solutions!
Question one: Animatronic dinosaur skin damage.
Solution: Animatronic Dinosaur skin is made up of silica gel and elastic cloth. In use, if the skin has a sharp weapon to be damaged, the user will need to sew the damaged position with a needle and thread, and then apply a layer of acidic glass glue to repair the damaged skin.
Question two: Animatronic dinosaur movement speed slowed.
Solution: Usually exercise is normal, the sudden speed slowed. This is due to the lack of voltage, resulting in the simulation of dinosaur motor speed is too slow, thus moving slower. Increase the voltage to solve the problem of slow speed.
Question three: There is a pause in the action.
Solution: The common state is to move, stop, the action is not continuous. This is due to power problems, and sometimes power off, you can check the chassis transformer is normal.
Question four: a part of animatronic dinosaur is not moving.
Solution: Animatronic Dinosaur common action has a roaring, guaranteed, Blink, and so on, if suddenly appear a part of the position does not move, this is the fuse broken, the user only need to connect the fuse can solve the problem.
Question five: The animatronic dinosaur plugged into power without any reaction.
Solution: Check whether the controller LED is lit, if the light is on, then replace the safety tube, if the light is not lit, should be remote control receiver or infrared sensor fault, replace the corresponding accessories.
If you have more questions about the animatronic dinosaur, you can discuss them with us.